If the signal strength displayed is less than 35, relocate the Touchpad or BAT-Connect. Once a network is determined, verify the signal strength. Note: Internet access allows for camera control, weather updates, and the ability to modify users.Ĥ. The Touchpad can access the internet directly through the BAT-Connect. The Touchpad should be directly connected to the BAT-Connect access point. Select the “Connect” option to see the available networks. For additional details, please refer to the Wall Mounting section.ģ. Existing wiring needs to be moved to the provided power adapter. Note: The Touchpad cannot run off-panel bus. The touchpad can be mounted on a wall or tabletop. ![]() Test the Touchpad by arming and disarming the panel from the Touchpad.Enter master code, then select Alula Cloud. To log in go to Settings and select Touchpad. ![]() If using cameras or user management features, you must log in to the Alula Cloud as the account owner.To confirm the number of Touchpads connected, log into your account. Check whether the panel is already full.A red light will flash on the panel if in wireless enrollment mode. Confirm the panel is disarmed and in wireless enrollment mode.Troubleshooting Steps if Enrollment Fails: If the wrong panel was selected, press the “Restart” button in the side menu. Upon success, it will show the DISARMED screen. After selecting the desired panel, the Touchpad will progress through stages of discovery and authentication. After a connection is established, the Touchpad will discover all devices on the network. Note: If connecting to a home network, enter router credentials at the Touchpad. Enroll the Touchpad by pressing the enroll button on the side of the panel until it beeps once and then selects the desired network.Refer to section “Touchpad Mounting Options” for mounting instructions. To view, all networks in range tap the “Show all networks” button at the bottom of the network list. The Touchpad cannot connect to the panel over anīy default, the Touchpad network list will show Connect+ and BAT-Connect access points. Note: If connecting to a home network router, the Connect+ needs to be connected to the same network via ethernet. If neither options areĪvailable, install a RE621 Touchpad Range Extender. If the signal strength displayed is less than 35, relocate the Touchpad or Connect+ panel. Connecting to the home router will give the Touchpad access to the internet which is required for camera control, weather updates, and the ability to modify users.Ĥ. The Touchpad can be connected to either the Wi-Fi DeviceLink card or the home router. If the “Connect” option is not available, press “Setup” then “Factory Default”. Power the Touchpad by applying AC power.ģ. Identify your network and verify signal strength before mounting it permanently.Ģ.Reconnect the panel’s AC power and backup battery.Install the Wi-Fi DeviceLink card in Slot 2 by carefully aligning the nylon retention posts and the 8-pin connector while pushing the card firmly until all posts are fully seated.Disconnect the panel’s AC power and backup battery.DeviceLink firmware must be v0.6.6.0 or newer. ![]() Note: DeviceLink hardware must be version D00 or newer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |